SAMPLE PACK - THIS CURRENT SAMPLE PACK INCLUDES 20 DIFFERENT BEARINGS
Notice: The image in this photo is only illustrative since the bearings available in this Sample Pack are constantly changing with the ones we currently have available. (Sometimes we may offer more pieces in the pack, sometimes less). Since we are often adding or removing bearings on this pack, prices may also fluctuate. Make sure to always check which bearings are available in this pack in the list bellow.
The "Sample Pack" is like a 'taster', which contains a variety of many different bearings for you to test and experience!
The “Exotic Dozen” Bearing Sample Pack includes 6x different R188 UQH Bearings, which consists of unique “full ceramic” and "full mixed ceramic bearings" that features 12 bearing balls. These amazing new UQH bearings have a super unique ceramic feedback, perfect for those who want to try different feedback flavors :) All bearings are tagged with their names so it's easier to identify once you receive them.
BEARINGS INCLUDED IN THIS SAMPLE PACK:
FULL CERAMICS:
1x DARK MOON 2.0 (12 Balls)
1x FULL MOON (12 Balls)
FULL MIXED CERAMICS:
1x THEBE
1x AMALTHEA
1x EUROPA
1x CALLISTO
Disclaimer!
Ceramic bearings can break! In case your bearing breaks during installation or removal, we do not offer replacements or refunds, so be very careful when installing or removing them, and pay attention to the following:
Be careful when installing or uninstalling ceramic bearings as they may break if your spinner bearing hole is too tight for them. Ceramic is a very brittle and hard material and it has no room to flex or bend. If the bearing hole of your spinner is too tight, i.e if it has too much glue, or dry glue leftover from a previous installation, or if your spinner was machined with a bearing hole slightly smaller than the standard, it is very important that you do not force push your bearing in or out. If you feel a strong resistance when installing or removing your ceramic bearing, stop immediately. You may want to make sure your bearing hole is very clean, with no glue residues before installing your bearing. If glue is necessary then you may apply a little bit of glue in the spinner bearing hole walls (never on the bearing) and try again. If you still feel it’s too tight for your ceramic bearing, do not install it on that spinner. Again, we do not offer replacements or refunds if you break your bearing!