SAMPLE PACK - THIS CURRENT SAMPLE PACK INCLUDES 20 DIFFERENT BEARINGS
Notice: The image in this photo is only illustrative since the bearings available in this Sample Pack are constantly changing with the ones we currently have available. (Sometimes we may offer 20 pieces in the pack, sometimes less or more). We are often adding or removing bearings from this pack, so prices also fluctuate. Make sure to always check which bearings are available in this pack in the list bellow.
The "Sample Pack" is like a 'taster', which contains a variety of many different bearings for you to test and experience!
This Sample Pack includes 20 different R188 UQH Bearings, a mix of hybrid ceramics, full ceramics and stainless steel. Perfect for those who want to try different feedback flavors :) All bearings are tagged with their names so it's easier to identify once you receive them.
BEARINGS INCLUDED IN THIS SAMPLE PACK:
FULL CERAMICS:
1x DARK MATTER
1x DARK ENERGY
1x HOT FUSION
1x COLD FUSION
1x SOLAR FLARE
1x SOLAR ECLIPSE ZrO2
1x SOLAR ECLIPSE Si3n4
1x LUNAR ECLIPSE ZrO2
1x LUNAR ECLIPSE Si3N4
HYBRIDS & SS:
1x OORT CLOUD
1x WHITE DWARF
1x NIBIRU 2.0
1x GOFAST
1x LIGHT SPEED
1x SUPERCLUSTER 2.0
1x JUPITER
1x ZERO-G
1x QUANTUM
1x REPTILIAN
1x DEEP SPACE
Warning!
Ceramic bearings can break! In case your bearing breaks during installation or removal, we do not offer replacements or refunds, so be very careful when installing or removing them, and pay attention to the following:
Be careful when installing or uninstalling ceramic bearings as they may break if your spinner bearing hole is too tight for them. Ceramic is a very brittle and hard material and it has no room to flex or bend. If the bearing hole of your spinner is too tight, i.e if it has too much glue, or dry glue leftover from a previous installation, or if your spinner was machined with a bearing hole slightly smaller than the standard, it is very important that you do not force push your bearing in or out. If you feel a strong resistance when installing or removing your ceramic bearing, stop immediately. You may want to make sure your bearing hole is very clean, with no glue residues before installing your bearing. If glue is necessary then you may apply a little bit of glue in the spinner bearing hole walls (never on the bearing) and try again. If you still feel it’s too tight for your ceramic bearing, do not install it on that spinner. Again, we do not offer replacements or refunds if you break your bearing!